Specifications

Connectors on Matrox Solios eA/XA 139
To build your own cable, you can purchase the following parts:
These parts can be purchased from third parties such as Digi-Key Corporation
(www.digikey.com).
36 GND N/A N/A Ground.
37 GND N/A N/A Ground.
39+,38- LVDS/TTL_AUX_IN3 M_AUX_IO5 M_DEV0/
M_DEV1/
M_DEV2/
M_DEV3
LVDS or TTL auxiliary signal (input), shared between all
acquisition paths for trigger input (trigger controller 3 on
acq path 0; 3 on acq path 1; 3 on acq path 2; 3 on acq
path 3) or user input, and dedicated to acquisition path 1
for field polarity, data valid, CSYNC, or HSYNC input.
40+,25- P2_LVDS/TTL_AUX_OUT0 M_AUX_IO10 M_DEV2 LVDS or TTL auxiliary signal (output) for acquisition path
2, which supports: user output (M_USER_BIT0), timer
output (M_TIMER1 on M_DEV2), or HSYNC output.
41 GND N/A N/A Ground.
43+,42- P1_LVDS/TTL_AUX_OUT0 M_AUX_IO10 M_DEV1 LVDS or TTL auxiliary signal (output) for acquisition path
1, which supports: user output (M_USER_BIT0), timer
output (M_TIMER1 on M_DEV1), or HSYNC output.
44+,29- P0_LVDS/TTL_AUX_OUT1 M_AUX_IO11 M_DEV0 LVDS or TTL auxiliary signal (output) for acquisition path
0, which supports: user output (M_USER_BIT1), timer
output (M_TIMER2 on M_DEV0), or VSYNC output.
*. Note that only signals defined for acquisition path 0 (those that begin with P0), the common auxiliary input signals (LVDS/TTL_AUX_), and the
grounds (GND) apply to the Matrox Solios eA/XA Single board. Only signals defined for acquisition paths 0 and 1 (P0 or P1), the common aux-
iliary input signals (LLVDS/TTL_AUX_), and the grounds (GND) apply to the Matrox Solios eA/XA Dual board.
†. These MIL constants represent the signals as of MIL 10. The signals that were previously represented by M_HARDWARE_PORTn became rep-
resented by M_AUX_IOn (where the value of n remained the same between the constants). For a complete list of changes between previous MIL
versions and MIL 10, see MilSoliosAnalogIOConversionTable within MIL Release Notes.
Pin
Hardware signal name
*
MIL constant for
auxiliary signal
†
Digitizer device
number for
auxiliary signal
Description
Manufacturer: NorComp, Inc.
Connector: 180-044-102-001
Backshell: 970-025-010-011