Specifications

128 Appendix B: Technical information
To build your own cable, you can purchase the following parts:
These parts can be purchased from third parties such as Digi-Key Corporation
(www.digikey.com).
Internal auxiliary I/O connector
The internal auxiliary I/O connector is a 50-pin low-profile IDC connector. It is
used to transmit timing and synchronization signals, and transmit/receive
auxiliary signals. The connector is located on the edge of the board, making the
signals accessible from inside the computer enclosure.
The pinout for this connector is as follows. Refer to the description of the external
auxiliary I/O connectors to establish if an auxiliary signal is specific to an
independent acquisition path and the type of signals that can be routed onto it.
Mating information
Manufacturer: NorComp, Inc.
Connector: 180-015-203L001
Backshell: 970-015-010-011
Pin A25
Pin A1
Pin B25
Pin B1
Board side
Pin Hardware signal name MIL constant for
auxiliary signal
*
Digitizer
device
number for
auxiliary
signal
Description
A1, B1 P0_LVDS_HSYNC_OUT HSYNC output for acq. path 0.
A2 GND Ground.
A3, B2 P1_LVDS_HSYNC_OUT HSYNC output for acq. path 1.
A4, B4 P0_LVDS_VSYNC_OUT VSYNC output for acq. path 0.
A5, B5 P1_LVDS_VSYNC_OUT VSYNC output for acq. path 1.