Specifications

126 Appendix B: Technical information
To build your own cable, you can purchase the following parts:
These parts can be purchased from third parties such as Digi-Key Corporation
(www.digikey.com).
36+,21- P1_LVDS_VSYNC_OUT N/A N/A VSYNC output for acq. path 1.
37+,23- P0_LVDS_AUX_IN1 M_AUX_IO11 M_DEV0 LVDS auxiliary signal (input) for acquisition path 0, which
supports: trigger input (trigger controller 1 on acq path 0),
user input, timer clock input, or quadrature input bit 1.
38+,39- OPTO_AUX_IN1 M_AUX_IO1 M_DEV0/
M_DEV1
Opto-isolated auxiliary signal (input), shared between both
acquisition paths for trigger input (trigger controller 3 on
acq path 0; 3 or 1 on acq path 1) or user input.
40+,25- P0_LVDS_VSYNC_OUT N/A N/A VSYNC output for acq. path 0.
41+,26- P0_LVDS_HSYNC_OUT N/A N/A HSYNC output for acq. path 0.
42 GND N/A N/A Ground.
43 TTL_AUX_IO_0 M_AUX_IO2 M_DEV0/
M_DEV1
TTL auxiliary signal (input/output), shared between both
acquisition paths for trigger input (trigger controller 2 on
acq path 0; 2 on acq path 1), user input, or user output
(M_USER_BIT4), and dedicated to acquisition path 0 for
timer output (M_TIMER2 on M_DEV0).
44 NC N/A N/A Not connected.
*. These MIL constants represent the signals as of MIL 10. The signals that were previously represented by M_HARDWARE_PORTn became rep-
resented by M_AUX_IOn (where the value of n remained the same between the constants). For a complete list of changes between previous MIL
versions and MIL 10, see MILSoliosCameraLinkIOConversionTable within MIL Release Notes.
Pin Hardware signal name MIL constant for
auxiliary signal
*
Digitizer
device number
for auxiliary
signal
Description
Manufacturer: NorComp, Inc.
Connector: 180-044-102-001
Backshell: 970-025-010-011