Specifications

Electrical specifications 109
Output signals in
LVDS format
No termination.
Output current (loaded 100 Ohm): 20 mA (typ).
Output voltage (loaded 100 Ohm):
• differential: 250 mV (min) to 450 mV (max).
• common-mode: 1.125 V (min) to 1.375 V (max).
• low: 1.02 V (typ), 0.9 V (min); high: 1.33 V (typ), 1.6 V (max).
Input signals in
TTL format
No termination.
Pulled up to 3.3 V with 4.716 k ohm.
Clamped to -0.7 V and to 5.7 V.
Input current: 1 μA (max).
Input voltage threshold: low of 0.8 V (max); high of 2.0 V (min).
Output signals in
TTL format
27 Ohm series termination.
High-level output current: -32 mA (max).
Low-level output current: +64 mA (max).
Output voltage: low of 0.55 V (max); high of 3.0 V (min) at -3 mA, 2.0 V (min) at -32 mA.
Opto-coupled input
signals
511 Ohm series termination.
Input current:
• low: 250 μA (max).
• high: 5 mA (min) (6.3 mA recommended) to 15 mA (max) (10 mA recommended).
Input voltage (with 511 Ohm series resistor only): low of 0.8 V (max); high of 4.06 V (min) (4.72 V recommended).
*. Operating voltages and currents apply starting from version 100 of Matrox Solios XCL.
†. This specification is supported by the following hardware signals: P0_LVDS_AUX_IN0, P0_LVDS_AUX_IN1, LVDS_AUX_IN0, and
LVDS_AUX_IN1.
Matrox Solios eCL/XCL-F (starting from version 200)
Operating voltage and
current (eCL-F)
Typical: 3.3 V, 2.67 A: 8.82 W
Typical: 12.0 V, 0.21 A: 2.48 W
Total dissipated by the board = 8.82 W + 2.48 W = 11.3 W (typical)
Operating voltage and
current (XCL-F)
Typical: 3.3 V, 0.0 A: 0.0 W
Typical: 5.0 V, 2.1 A: 10.5 W
Typical: 12.0 V, 0.00 A: 0.0 W
Total dissipated by the board = 0.0 W + 10.5 W + 0.0 W = 10.5 W (typical)
I/O Specifications
Matrox Solios eCL/XCL dual-Base/single-Medium (starting from version 100)