Specifications

- 312 -
Routing an Audio Channel through Insert Effects
1. Open the Monitor window.
2. Locate the audio channel you want to add insert effects to, and click on
its Insert button.
● For stereo Tracks, there will only be one Insert button, for the left channel in
the audio channel pair. However, both channels in the pair are routed
through the Insert effect (provided it’s a stereo-input effect - see above).
The Insert Effects window opens. This looks much like the Send Effects window,
but has no Effects Master knobs or output bus pop-up menus.
3. Select and activate an Effect, and make settings for it just as with regular
Send Effects.
4. If required, use the parameters in the effect’s control panel to adjust in-
put level and balance between dry and effect signal.
Since the entire signal passes through the effect, you will only hear the “wet”
signal on the output, unless you adjust the settings of the effect to make the
output include some of the “dry” sound as well.
● Not all Effect Plug-ins have dry/wet balance controls.
5. If you want to, repeat steps 2-3 for the other effect processors.
Avoid activating effect processors that you don’t use, since this draws some
extra processor power. To minimize the processor load, pull down the Effect
type pop-up for the unused processors, and select “No Effect”.
• To turn off an Insert Effect, click on its Power button.