Specifications

- 203 -
4. Click on the button below the Send Level knob to pull down the Send
Routing popup menu.
This popup menu contains the eight VST effects, all activated Buses and each
side (left/right) of the eight Groups.
5. Select one of the effects, Groups or Buses on the popup menus to route
the send there.
Since the sends are in mono, you can select each side of an output Bus inde-
pendently.
6. Repeat steps 3 to 5 for the other sends as desired.
Clicking the Pre button will allow you to send the signal of an audio channel
to an effect or a bus, independently of the channel’s fader and mute settings.
Use this for insert type effects, etc.
● It is important to note that the Routing is independent for all Sends on all au-
dio channels!
If for example you route Send 1 for channel 1 to the first effect processor in
the Mixer Effect window (running “Choirus” in the example above), you are
free to route Send 1 for the next channel to whatever effect processor or Bus
you wish!