Specifications

55
Note: Receive Formant Motion/Current Formant Motion can be used only if the EXB-
RADIAS is installed.
Receive Current Combi/Current Prog/1 SEQ
Receive the respective data from the M3 into the editor.
Transmit Current Combi/Current Prog/1 SEQ
Transmit the respective data from the editor to the M3. This operation does not write the data
into the M3's internal memory. You'll need to write (save) it if necessary.
Synchronize KARMA User GE
This command loads the M3’s KARMA User GE data (User GE bank U-A through U-H) into
the editor. This command is available only in Combination mode and Program mode when
the KARMA tab is displayed.
Synchronize RAM Banks
Loads the multisample names from the M3’s RAM bank into the editor.
This allows you to view the multisample names in the editor when you’ve selected RAM
Mono/RAM Stereo from the OSC Bank list.
Synchronize EX-USB Banks
Loads the multisample names from the M3’s EX-USB-PCM bank into the editor.
This adds the EX-USB-PCM bank to the OSC Bank list, allowing you to select multisamples
from the EX-USB-PCM bank.
Note: These Receive and Transmit commands use KORG SysEx MIDI Dump to send or
receive data, or to synchronize the data between the M3 and the software.
Don’t touch the keyboard or the mouse of your computer while data is being sent or
received. Also, don’t touch the panel switches or the keyboard of the M3.
Import
This command loads M3 or M50 PCG data into the editor.
Importing of the following data is supported: PCG files from the M3 XPANDED (new PCM),
PCG files from the original M3 (old PCM), PCG files of the M50, and files with an extension of
[.M50all] that were created by M50 Editor.
Save as Default
Writes (saves) the global mode Software Setup settings of the editor as the default settings
that will be used when you start up the editor.
Note: These utilities can be selected only in the editor’s global mode Software Setup page.
Select Auto Load File
In the Software Setup tab, use “Load data file automatically” to select the desired file.
Note: Refer to “Load data file automatically.
All Sound Off
Depending on the host application, "hung" notes may have sometime occurred
while operating the host's functions.
If this symptom occurs, please execute the "All Sound Off" command.