Specifications

with Blue & White G3s:
ATTO ExpressPCI SCSI HBA card EPCI-DC (ExpressPCI Dual
Channel Ultra/WIDE HBA) only, with the following requirements:
ATTO ExpressPCI Firmware v1.4.4 f1
ExpressPro-Tools v2.3.2 or higher with Synch Transfer Rate set to 20
(10) and PCI Burst Rate set to 32 bytes
ATTO ExpressPCI Firmware v1.4.4 f1 is available at:
http://www.digidesign.com/download/ptutil.html
ATTO ExpressPro-Tools v2.3.2 is available at:
http://www.attotech.com/software
— OR —
Adaptec Power Domain SCSI HBA cards including:
● 2940UW
● 3940UW
with the following requirements:
Firmware v4.1
PowerDomain Control v5.1 with cards set to "Fast-SCSI:10" in the
Control Panel
Current Adaptec drivers are available at:
http://www.adaptec.com/worldwide/support/driverindex.html
Previous drivers are available at: ftp.adaptec.com/mac/scsi/
MIDI: Both USB and serial MIDI interfaces work effectively with Pro
Tools. Digidesign recommends using a serial MIDI interface, as they
offer the tightest possible MIDI timing. Serial MIDI interfaces require
either a Mac serial port or a qualified modem-to-serial port adapter.
Digidesign currently supports the GeeThree Stealth Port and Griffin
gPort installed in the modem port (thereby not using a PCI slot).
When using the GeeThree products with OS 9.0.4 the latest version
of the Stealth Port extension (v1.0.3) is required. It is available here:
http://www.geethree.com/download.html
DSP Farm and SampleCell II Support: The PCI Matchmaker chip
on a DSP Farm must be rev QC or QE (check the end of the line
directly below “PCI Matchmaker” on the chip) to be compatible. Cards
with rev Q chips can be upgraded.
d24 Support: Some d24 cards may experience recognition problems
in the 400 MHz Blue & White G3 or G4s with AGP Graphics. If so,