Specifications

Pro Tools Free For Windows 98/Me - System Requirements
Important information
The system requirements on this
page are meant for general
guideline purposes only.
Digidesign cannot guarantee
compatibility with any particular
computer system, or various
components installed on it.
Due to the giveaway nature of
Pro Tools Free, this product is not
eligible for technical support by
telephone, fax or email. If you do
have problems or technical
questions, check the Pro Tools
FREE Technical & Customer
Support Information page
for
resources available to you.
Because Pro Tools FREE is limited
to one third of the audio tracks
supported by Pro Tools LE, users
may find that it is compatible
with some older/slower
computers which are not included
on these pages.
Digidesign Hardware Not Required
Digidesign Software Version
Pro Tools 5.0.1 FREE Revision 2
Compatible CPU Models
Highly Recommended:
● Intel Pentium III -
Processors of all speeds
are compatible, desktop
or laptop, single
processor
Have been reported as
compatible by some users:
Additional Computer
Requirements
● System Software:
Windows Me or Windows
98, Second Edition
● Total System RAM: 128
MB minimum 192 MB
recommended (Additional
RAM required for
simultaneous use with
MIDI sequencers.)
● Intel chipset
● Phoenix or Award BIOS
(recommended)
● CD-ROM drive for
software install
● AGP or PCI graphic card
● Monitor, color required,
minimum resolution of
1024 x 768
● Storage: A large, fast,
hard drive for audio.
● For maximum
performance, a dedicated
ATA/IDE or SCSI disk
drive(s), such as those
qualified with Pro Tools
LE
, should be used.
Third-Party MIDI Controllers &
Interfaces
Optional Digidesign Software
Optional Digidesign Hardware
SampleCell II Plus - SampleCell
software must be installed before
Pro Tools FREE is installed.
Optional Third-Party SCSI
HBA Card
Adaptec AVA-2906
Maximum Performance
Guidelines
Pentium III at 500 MHz or higher