Specifications

● VST Floppy Drive (model FDUSB-M)
● Imation SuperDisk
● NewerTechnology uDrive
● Pace USB Floppy Enabler
Apple's revised USB support allows for booting from a USB drive, therefore
you should not boot up your system with an authorization disk inserted in
the USB Drive.
SCSI HBA Card NOT required: Although Pro Tools LE supports a full 24
tracks of record and playback on a dedicated ATA/IDE hard drive, use of a
SCSI HBA card with a SCSI drive can increase some performance aspects
of your Digi 001 system: for more information refer to the
Audio Storage
Requirements
page. Optional SCSI HBA cards bundled (by Apple) with
Power Macintosh computers are not compatible with this configuration due
to the lack of NV RAM to store Pro Tools desired SCSI transfer rate.
The following SCSI HBA cards are qualified with the G4s listed at the top
of this page:
ATTO ExpressPCI SCSI HBA cards EPCI-DC (ExpressPCI Dual Channel
Ultra/WIDE HBA) only, with the following requirements:
● ATTO ExpressPCI Firmware v1.4.4 f1, available at:
http://www.digidesign.com/download/ptutil.html
● ExpressPro-Tools v2.3.2 or higher with Synch Transfer Rate set to
20 (10) and PCI Burst Rate set to 32 bytes, available at:
http://www.attotech.com/software/
— OR —
Adaptec Power Domain SCSI HBA 2906 with the following
requirements:
● Firmware v1.1
● PowerDomain Control v5.1 with cards set to "Fast-SCSI:10" in the
Control Panel
● Current Adaptec drivers are available at:
http://www.adaptec.com/worldwide/support/driverindex.html
Previous drivers are available at: ftp.adaptec.com/mac/scsi/
Digidesign Compatibility Documents Index