User's Manual

1
Users Manual
It is wireless presenter as a laser pointer, a wireless mouse, a wireless keyboard and a portable
storage device. It is tailored as a convenient handy-tool for presentations, teaching, meetings,
speeches, training.
It consists of two parts: transmitter and USB receiver.
I. Setup:
Plug the receiver into the USB port on your PC. The system will automatically search for the new
hardware and complete the setup.
( Attention : you may need Win98 disk if your computer runs under Win98/SE operating system..)
II. Function:
Start
Mouse pointer up
Start slide show
Mouse pointer left
Page up
M ouse le ft click
Laser
Escape
Mouse pointer right
Blank screen
Mouse pointer down
Page down
M ouse right click
Switching be twee n
Ke yboard and mo use
UBS plug
LED
A) When the switch is put on “KEYBOARD”, it functions as a wireless keyboard as below:
● Laser: press “LASER POINTER ” key to generate red laser light
● Page up: press “ LEFT “key. The function is like Page Up on a keyboard
● Page down: press “ RIGHT “key. The function is like Page Down on a keyboard
● Start: Press “∧” key and generate start function of computer
● Blank screen : press “∨ “key to make function
( Press once again to come back to the show status ).
● Shortcut : press “< ” key to start the slide show through shortcut after you open one file under
PowerPoint
● Escape: press “>” key to make escape function on computer
B) When you select the switch on “MOUSE”, it functions as a wireless mouse as below：
● Laser: press “LASER POINTER ” key to generate red laser light
● Mouse Left button function: press “ LEFT ” key
● Mouse Right button function: press “ RIGHT ” key
● Mouse Up: press “∧ “key and make the mouse point move up
● Mouse Down: press “∨ “key and make the mouse point move down
● Mouse Left move: press “<” key and make the point move to left
● Mouse Right move: press “> “key and make the point move to right
( Tip: pinpoint the mouse to get exact position of the pointer, pointer will move faster when
pressing without pause.)
C) Built-in flash memory is available (64/128/256/512/1024MB)
III. Technical parameters:
Remote Controller Receiver
Control Distance
＞25 meters
Hardware IBM PC/AC & NoteBook, Apple
Battery
AAA(7)× 2
Operating System Windows98/ME/2000/XP, Linux, Mac
Working Voltage 2.4—3.5V Compatible interface USB1.1 USB2.0
Wireless sending method RF Working Voltage USB bus cable supply
(4.5—5.5V)
Frequency 433.92Mhz Wireless receiving method RF
Modulation OOK Frequency 433.92Mhz
Output Power 0dbm Modulation OOK
Laser Power <1mw/5mw Receiver sensitivity -100 dbm
Wave length 650nm Size
73× 27× 17mm
Size
119× 31× 17mm
Weight 16g
Weight 58g
!