Manual Junkers JU-52 1630mm Olympiad 1936 VQA113

CA
When you are satisfied with the alignment,
use a pencil to trace around the right and
left of the stabilizer where it meets the
fuselage (9B).
Remove the horizontal stabilizer from the
fuselage.
Using the sharp hobby knife, carefully cut
away the covering inside the lines which
were marked above (9C).
* WARNING: When removing any covering
from the airframe, please ensure that you
secure the cut edge with CA or similar
cement. This will ensure the covering
remain tight.
9
9A
9B
9C
9D
Insert the vertical fin into the fuselage,
ensuring that it is seated property
on the horizontal stabilizer (9D).
9E