Operation Manual

20
ENGLISH
CAUTION: Do not immerse the Avid IF 2 stimulator, lead wires, AC
Adapter or batteries in water.
Maintenance, care and cleaning of the Avid IF 2 is quick and easy when
these instructions are followed:
Case
Clean the outside of the Avid IF 2 case as needed with a damp cloth and
mild soap. Never immerse the Avid IF 2 or batteries in water, alcohol or
other fluids since this could seriously damage the internal electronics.
Avoid using cleaning fluids or solvents to remove stains and dirt, as such
liquids may damage the casing. DO NOT use abrasive materials on the
LCD viewing area.
Lead wire
Do not bend or crimp the lead wire. Do not use the lead wire if it is moist or
wet – allow to air dry for at least one hour. Always remove the lead wire by
firmly grasping the connector. If possible, tuck in excess length of the lead
wires to avoid interference with normal activity. These wires only need to be
cleaned if they become dirty. Wipe with a damp cloth and dry thoroughly.
Storage
When not in use, store the Avid IF 2 in its carrying case to prevent unintentional
damage. During periods of prolonged storage, remove all Power Packs to prevent
possible damage caused by battery leakage or corrosion.
Power Pack information
Non-rechargeable alkaline Power Pack
Storing the alkaline Power Pack:
 •Store the Power Packs in a cool, dry place. Do not leave the Power Pack
exposed to direct sunlight. Do not store the Power Pack at temperatures
below 30˚ F or above 100˚ F.
 •If you will not be using the Power Pack for a month or longer, remove it
from the unit and store in a cool, dry, clean place.
 •Actual Power Pack run-time depends upon the energy demands made by
the equipment it powers and the design of the equipment.
 •Alkaline Power Packs can be recycled, when the charge is depleted.
Please contact your local recycling center for proper disposal of used
Power Packs.
Care and Maintenance