Operation Manual

ENGLISH | 13

ENGLISH

These are the screens that appear during most of your treatment time,

depending on the modality being used. Press the (+) or (–) button to change

stimulation intensity. For your safety, the keypad locks after 30 seconds of

inactivity. To unlock the keypad, press the (–) button and proceed to use

the (+) button to increase intensity. At any time, you can press the (PAUSE)

button to pause the treatment. Pressing the (PAUSE) button again will restart

the treatment. The intensity will slowly increase from zero back to its last

setting. If at any time you wish to discontinue treatment, press the (ON/OFF)

button and the device will shut down.

• The upper left corner of the screen displays the battery status and indicates

whether the AC Adapter is plugged into the device.

• The center top of the screen displays the protocol number you are using.

• The upper right corner displays the type of protocol currently running

(e.g. IF).

• The middle of the screen displays the amplitude (intensity) of the

stimulation. Below the amplitude is a description of button functions.

If a button does not have a function, it will not appear on the list and

pressing the button will result in a beep.

• The bottom of the screen displays the time. Once treatment has started,

treatment time counts down in hours, minutes and seconds. If the

treatment is continuous, the timer will start at 00:00:00 and count up.

NOTE: It is normal for the Avid IF 2 to become warm during treatment.

INTERFERENTIAL treatment screen

Normal Running Screens

0mA

(P) Protocol

00:40:00

15mA

(S) Vector

(PAUSE) Pause

00:39:59

Before starting treatment While treatment is running

* If the time has an asterisk next to it, another treatment will follow the current one.