User Manual

Table Of Contents

Pull the rudder out of the vertical fin.

Carefully, push the vertical fin into the

slot on the fuselage as shown .

Trial fit the vertical fin in position. Using

a 90 degree triangle, ensure that the

vertical stabilizer is perpendicular to the

horizontal stabilizer .

Using a pencil, trace around the vertical

stabilizer where it meets the fuselage.

Remove the vertical stabilizer from the

fuselage.

Using s sharp hobby knife, carefully cut away the

covering below the lines which were drawn in the

previous steep. Do not cut into the woods as this

will affect the structural integrity of the stabilizer .

Cut away only

the covering

Insert the vertical fin into the fuselage, precisely align

the vertical stabilizer as described in step 6C.

Apply the thin CA glue on the vertical stabilizer where it

contacts the fuselage.

! Securely glue together. If coming off during fly,

you lose control of your air plane.

6- Vertical Stabilizer