User Manual
Table Of Contents
7- Stabilizer
Slowly, slide the horizontal stabilizer through
the vertical stabilizer.
7A
When you are satisfied with the alignment, use
a pencil to trace around the top and bottom of
the horizontal stabilizer where it meets the
vertical stabilizer. Remove the horizontal stabilizer.
7B
Check the alignment of the horizontal stabilizer,
the distance must be equal on both sides (A=A’).
Vertical stabilizer
Horizontal stabilizer
A
A’
TOP VIEW
Cut away only
the covering
both sides.
Remove the horizontal stabilizer
from the vertical stabilizer. Using a straight edge
and a sharp hobby knife, carefully cut away
the covering inside the lines which were marked
above. Be cautious not to cut into the wood-this
will weaken the structure.
7C