User Manual

805
805
D
A
N
G
E
R
D
A
N
G
E
R
Note: Cut out the stickers and apply them in the proper area. Do not peel the backing paper off all at once.
Peel off one corner of the backing and cut off with scissors.
Arrange sticker on model and when satisfied adhere the corner without backing.
Carefully peel back the rest of the backing while at the same time adhering the rest of the sticker.
Try not to make air bubbles, if there are some, carefully puncture sticker (center of bubble) but not model surface with
the tip of the knife or sharp pin and squeeze out the air.
At curves stretch sticker and apply a little heat so that no ceases occur.
Cut off the excess that is produced.
Decal of Otter Canada version
Decal of Otter Swiss version
Decal application: See the label on top box
15- Decal
2x8mm self tapping screw
...........4
3x15mm screw
.........2
3x12mm self tapping screw
...........2
3mm blind nut
...........2
15- Shield and Wing brace
1mm
2mm
The rectangular hole on the
fuselage is pre-laser cut at
factory.
Cut away only the covering.