User Manual

Laser cut carton template
Aluminum tube
Horizontal stabilizer
Laser cut carton template
Using a sharp hobby knife, carefully cut away
the covering inside the lines which were marked
above. Be cautious not to cut into the wood-this
will weaken the structure.
Cut away only the
covering and inside
the line
Again, slide the holder onto the horizontal stabilizer
Apply the thin CA glue on the vertical stabilizer
where it contacts the holder.
Apply the thin CA glue on the
horizontal stabilizer where it
contacts the holder.
CA
CA
Thin CA
Thin CA
9- Stabilizer Continued
9A
9B
9C
Carefully, insert the vertical stabilizer
into the slot on the fuselage as shown.
Check the incidence angle of the horizontal
stabilizer using the laser cut carton template
- Slide the aluminum tube through the fuselage.
- Slide the left and right carton template through
the aluminum tube and the horizontal stabilizer
as shown (see pic. 9D)
Left carton
template
Right carton
template
Aluminum tube
Horizontal
stabilizer
9D