User Manual

! Securely glue together. If coming off during fly,
you lose control of your air plane.
Apply CA glue
both sides.
(thin CA)
CA
Apply thin CA glue into the slot where
the fuselage meet the horizontal stabilizer.
Install the horizontal stabilizer onto the fuselage and adjust the alignment as
described in steep 13A.
Note: it is important to ensure that the horizontal stabilizer is also level in regards to the
fuselage.
Apply the thin CA along the area where the covering was removed in the previous step and to the
fuselage where the horizontal stabilizer mounts .
B
B’
B=B’
Trial fit the vertical fin in position. Using
a 90 degree triangle, ensure that the
vertical stabilizer is perpendicular to the
horizontal stabilizer (14C).
Using a pencil, trace around the vertical
stabilizer where it meets the fuselage.
Remove the vertical stabilizer from the
fuselage.
Pull the rudder out of the vertical fin.
Carefully, push the vertical fin into the
slot on the fuselage as shown (14B).
CA
90 degree
triangle
14- HORIZONTAL STABILIZER & VERTICAL STABILIZER
14A
14B
14C