User Manual

Using a aluminum motor mounting plate

as a template, mark the plywood motor

mounting plate where the four holes are

to be drilled.

Remove the aluminum motor mounting

plate and drill a 1/8”(3mm) hole through

the plywood at each of the four marks

marked .

3mm

! Align the mark on wooden motor mounting plate

with the mark on the fire-wall.

Using a wooden motor mounting plate as a template,

mark the fire-wall where the four holes are to be drilled.

To muffler

Filler tube

To engine

3x35mm screw

Rubber stopper

Checking for leaks - block the vents and blow into the

feed - if in doubt submersing the tank in a blow of

water will show up any problems.

Blow

Water

Siai Marchetti SF-260

19- Engine continued

20- Fuel tank

21- Electric Motor

Reposition the engine on the engine mount

beams, aligning it with the holes. Secure the

engine to the engine mount using four

3x25mm screws.

Note: Apply Silicon sealer to each of the

3x25mm screw and nut.

.......4

3x25mm screw

Washer

.......4

3mm nut

.......4

21A

21B

21C

3mm