User Manual

A
B
Draw the center line
on the wing joiner
- Trial fit each part before gluing . Be certain that there are no gaps.
If the parts will join, but with a gaps, sand or trim the parts a little at
a time until the parts meet exactly with no gaps.
- Check for the correct dihedral angle
Before gluing:
- Draw the center line on the wing joiner.
30 min. Epoxy
Coat one half of the dihedral brace with epoxy up
to the center line. Install the epoxy-coated side of
the dihedral brace into the wing joiner cavity up to
the center line.
A
B
CA
6x20mm dowel
2x6mm
1.5mm
1.5mm
9- Fixed gear installation
Siai Marchetti SF-260
10- Joining the wing halves
L/R
2x6mm self tapping screw
.....................4