User Manual

Table Of Contents

Vis 3x10mm

......2

Elevator control horn

...........1

Note: The rectangular hole

for the control horn installation

is pre- cut at factory.

Apply a thin layer of machine oil or petroleum jelly to only the top and bottom of

the trailing edge of the elevator, then push the elevator and its hinges into the hinge

slots in the trailing edge of the horizontal stabilizer.

When satisfied with the and alignment, hinge the elevator to the horizontal stabilizer using

CA glue.

Hinge

Petroleum jelly

STABILIZER

Thin CA glue

2mm

Test-fit one end of the “U” torque rod into

each elevator half before glue the elevator

hinges to the horizontal stabilizer.

Cut away only

the covering

both side

Horn

Tail wheel mount

Fuselage

Rudder

Gear

Side view

Hinge line