User Manual

Trial fit the vertical stabilizer in place . Check the alignment
of the vertical stabilizer. When you are satisfied with the
alignment, use a pencil to trace around the right and left
of the stabilizer where it meets the fuselage.
Cut away only the covering
on the left and right side.
Remove the vertical stabilizer from the fuselage.
Using the sharp hobby knife, carefully cut away the
covering inside the lines which were marked above.
A
B
Realign the vertical stabilizer , ensure that the vertical
stabilizer is perpendicular to the horizontal stabilizer.
Then glue the vertical stabilizer into the fuselage, using
a generous amount of 5 min. Epoxy. Apply thin epoxy
to each of the two joints and the entire bottom edge of
the vertical stabilizer, use a generous amount to
ensure to strong bond.
5 min.
Epoxy
11
12
13
2mm
3x12mm screw
CA
Apply a thin layer of petroleum
jelly to only the pivot point of the
torque rod bearing.
Glue the rudder torque rod bearing into the slot you cut previously in the vertical stabilizer,
using a thin layer of CA glue.
Petroleum
jelly
FUSELAGE - SIDE VIEW
VERTICAL STABILIZER
3x12.......2
....................2
TAIL WHEEL