User Manual

35mm
19mm
HORIZONTAL STABILIZER
Cut two slots (only the covering) on the
top and along the trailing edge of the
horizontal stabilizer.
TOP VIEW / Draufsicht
TOP VIEW / Draufsicht
19mm
35mm
1
Full the elevator out of the
horizontal stabilizer.
2
Cut away only the
covering both side
Cut away only the covering on the
top and bottom
3
4
The slot on the horizontal stabilizer and the slot
on the fuselage must be coincidental.
A A
A=A
Trial fit the horizontal stabilizer in place . Check the alignment
of the horizontal stabilizer. When you are satisfied with the
alignment, use a pencil to trace around the top and bottom
of the stabilizer where it meets the fuselage.
5
HORIZONTAL STABILIZER - VERTICAL STABILIZER