User Manual

IMPORTANT:
Please do not clean your model with pure alcohol, only use liquid soap with water or use glass cleaner to clean on surface of
your model to keep the colour not fade.
All details are subject to change
without notice !
Technische Anderungen und Irrtumer
vorbehalten !
CA
X
2x6mm
..........6
1mm
Note: Cut out the stickers and apply them in the proper area. Do not peel the backing paper off all at once. Peel off one corner of the backing and cut off with
scissors. Arrange sticker on model and when satisfied adhere the corner without backing.
Carefully peel back the rest of the backing while at the same time adhering the rest of the sticker.
Try not to make air bubbles, if there are some, carefully puncture sticker (center of bubble) but not model surface with the tip of the knife or sharp pin and
squeeze out the air.
At curves stretch sticker and apply a little heat so that no ceases occur. Cut off the excess that is produced.
95 ~ 100mm
30mm
15mm
Aileron
Rudder
15mm
30mm
Querruderausschlag
Seitenruderausschlag
Do not try to fly an out-of balance model!
Uberprufen Sie vor dem Flug den Schwerpunkt.
15mm
15mm
Elevator
Hohenruderausschlag
Flap
20mm
LIGH
DECOR
BALANCE
FUEL
12 US. GALS
100 OCTANE
US.ARMY LK4A
AIRFORCE SERIAL NO 44 74298
Masking tape
A
B
5 min. Epoxy