User Manual

Table Of Contents

! Securely glue together If coming off during

fly, you lose control of your air plane.

Cut away only

the covering

both side

Remove the horizontal stabilizer from the fuselage.

Using the sharp hobby knife, carefully cut away the

covering inside the lines which were marked above.

Install the horizontal stabilizer into the fuselage and

adust the alignment as described in steep 5B. Secure

the horizontal stabilizer in place using CA glue.

When you are satisfied with the alignment,

use a pencil to trace around the top and

bottom of the stabilizer where it meets the

fuselage.

* WARNING: When removing any covering from the airframe,

please ensure that you secure the cut edge with CA or similar

cement. This will ensure the covering remain tight.

B’

B=B’

Aluminum wing joiner

Apply a thin layer of machine oil or petroleum jelly

to only the pivot point of the hinges on the elevator,

then push the elevator and its hinges into the hinge

slots in the trailing edge of the horizontal stabilizer.

There should be a minimal hinge gap.

When satisfied with the and alignment, hinge the

elevator to the horizontal stabilizer using CA glue.

Hinge

Petroleum jelly

STABILIZER

Note: the hole on the center of

the stabilizer must be coincidental

with the center line of the fuselage.

Control horn

...........2

Note: The slots for the control horn

installation are pre- cut at factory.

Cut away only

the covering.