User Manual

Firewall
90mm
(3.54”)
B’
B
B=B’
A
A=A’
A’
! Engine thrust on balk head
is already adjust at factory
Attach the aluminum motor mounting
plate on to the motor and secure it in
place with four screws ( included with
motor set).
Push the four 5x35mm bolts through the fire-wall as shown (5).
Reposition the plywood motor mounting plate and secure
it in place with twelve 5xmm nuts and washers (6).
Note: B=B’(Side-view) and A=A’(Top-view)
Using a plywood motor mounting plate as a template,
mark the fire wall where the four holes are to be drilled .
Motorspant
TOP-VIEW / Draufsicht
SIDE-VIEW / Seitenansicht
Sturz und Zug beachten!
Sperrholztrager Platten zusammenkleben, wie gezeigt ausrichten
und Locher bohren.
Motor nach untenstehendem Schema einbauen.
Fur optimale Leistung empfehlen wir folgende Komponenten:
-Brushless-Motor PICHLER BOOST 60
-Brushless Regler PICHLER XQ-70
-LiPO Akku LEMONRC 3700-5S
-Luftschraube 12*6 - 13*8
For maximum performance, we recommended
the following:
-Brushless-Motor PICHLER BOOST 60
-Brushless Regler PICHLER XQ-70
-LiPO Battery LEMONRC 3700-5S
-Propeller 12*6 - 13*8
X4
X16
X12
5x35 screw
5mm washer
5mm nut
Remove the plywood motor mounting plate and drill a
13/64”(5mm) hole through the fire-wall at each of the four
marks marked above.
A
B
C
5mm
13/64”
D
2