User Manual

1- Using a pencil, mark the line on the braces.
Line
2- Trial fit the horizontal tail joiner into one of the horizontal tail panel, It should insert smoothly up to the line marked
above. If the fit is over tight, it may be necessary to lightly sand the brace.
3- Remove the brace and coat one half of the brace with 30 minute epoxy up to the line.
4- Install the epoxy-coated side of the brace into the horizontal tail brace cavity up to the line.
5- Do the same way with other horizontal tail.
Carefully slide the horizontal tail panels together,
ensuring that they are accurately aligned. Firmly
press the two horizontal tail panels to the
horizontal tail center, Making sure that the ā€œVā€ of
dihedral brace is positioned correctly.
LEFT HORIZONTAL TAIL PANEL RIGHT HORIZONTAL TAIL PANEL
HORIZONTAL TAIL CENTER
KA3
Rear tail brace (Ka3)
A
A’
A = A’
Plastic control horn
and back plate
2x30mm screw
.....2
...........4
Control horn
Control horn
2
1
Front tail brace (G)
Left and Right
Tail brace (S)
Left and Right