User Manual

Firewall
B’
B
B=B’
A
A=A’
A’
TOP-VIEW
SIDE-VIEW
! Engine thrust on balk head
is already adjust at factory
Using a aluminum motor mounting plate as
a template, mark the plywood motor mounting
plate where the four holes are to be drilled (2).
Remove the aluminum motor mounting
plate and drill a 1/8”(3mm) hole through
the plywood at each of the four marks
marked .
3mm
2
Note: The aluminum motor mounting included
with electric motor set.
! Engine thrust on balk head
is already adjust at factory
X
To muffler
Filler tube
To engine
Rubber
stopper
Cap
Stopper
4mm
5
6
7
BOTTOM - VIEW / Unteransicht
E = 110 - 113mm
E
Checking for leaks - block the vents and blow into the
feed - if in doubt submersing the tank in a blow of
water will show up any problems.
Blow
Water
...4
5x70mm screw
5mm Washer
5mm Nut
..................16
.................12
CA
1
5mm