User Manual

CA
1- Insert the tail wheel pushrod into the hole on the tail gear control
horn (as show).
2- Install the tail wheel control horn in place.
4- Secure the tail wheel control horn in place using a 5/64”(2mm) screw set,
Ensure smooth non-binding movement.
5- Installing the tail wheel hatch (H) in place using a four 5/64x25/64”(2x10mm) self tapping screws.
6- Attach the tail wheel doors (D) in place using CA glue.
21- Tail gear
1
3
4
5
2
5/64 in.(2mm) I.D collar
2x10mm
screw
...............1
Tail landing gear
..........1
............1
2x3mm screw
............4
2x10mm screw
.................1
Tail wheel control-
horn
2mm I.D collar
6
3- Instal the tail wheel gear in place.
BOTTOM-VIEW
H
D
Securely glue together. If coming
off during flight, you lose control
of your air plane.
5 5
Bottom view
3/8 in. (9.5mm)
push the elevator and its hinges into the hinge slots in
the trailing edge of the horizontal stabilizer. There
should be a minimal hinge gap.
When satisfied with the and alignment, hinge the elevator
to the horizontal stabilizer using thin CA glue. Make
sure to apply a thin CA glue to the top and bottom of both
hinges and to inside the hinge slots. Repeat the previous
procedures to hinge the second elevator to the other side
of the horizontal stabilizer.
Control horn
................2
2x12mm screw
..........4
20- Elevator installation
Vergewissern Sie sich, sauber geklebt zu haben.
Andernfalls konnen Probleme mit der Flugeigenschaft
auftreten!
CA