User Manual

6- Engine - 2T
Align the engine center with
fire-wall marked line (A=A’)
A
A’
FRONT VIEW
7- Electric Motor
Using a aluminum motor mounting plate as a template, mark the
Fire-wall where the four holes are to be drilled .
Remove the aluminum motor mounting plate and drill a 1/8”(3mm)
hole through the fire-wall at each of the four marks marked .
Note: The aluminum motor mounting included with electric motor set.
3mm
X
To muffler
Filler tube
To engine
Rubber
stopper
Cap
Stopper
After confirming the direction . Insert
and tighten the screw.
4mm
Checking for leaks -
block the vents and blow
into the feed - if in doubt
submersing the tank in a
blow of water will show
up any problems.
Blow
Water
2
1
3