User Manual

A
B
Cut away only the covering both
the right and left side
Securely glue together. If coming off during flight, you lose control of your air plane.
1-Trial fit the horizontal stabilizer in place . Check the
alignment of the horizontal stabilizer. When you are
satisfied with the alignment, use a pencil to trace
around the right and left of the stabilizer where it
meets the fuselage.
2-Remove the horizontal stabilizer from the fuselage.
Using the sharp hobby knife, carefully cut away the
covering inside the lines which were marked above.
4-Install the horizontal stabilizer into the fuselage and
adust the alignment as described in steep 1.
5-Wipe off any excess epoxy using a paper towel and
rubbing alcohol.
Allow the epoxy to cure before proceeding to next
step.
3-Spread epoxy (30 min.) Onto
the right and left and bottom of
the horizontal stabilizer along
the area where the covering was
removed and to the fuselage
where the horizontal stabilizer
mounts.
Cut away only the covering both
the top and bottom.
A
B
Securely glue together. If coming off during flight,
you lose control of your air plane.
Apply a thin layer of machine oil or petroleum jelly to only
the pivot point of the hinges on the elevator, then push the
elevator and its hinges into the hinge slots in the trailing
edge of the horizontal stabilizer. There should be a minimal
hinge gap.
When satisfied with the and alignment, hinge the elevator
to the horizontal stabilizer using 5 minute epoxy. Make
sure to apply a thin layer of epoxy to the top and bottom
of both hinges and to inside the hinge slots. Repeat the
previous procedures to hinge the second elevator to the
other side of the horizontal stabilizer.
Hinge
Petroleum jelly
STABILIZER
A
B
Apply 5 min.
Epoxy both the
top and bottom.
A
A’
A=A’
B
B’
B=B’
10-
Horizontal Stabilizer / Hohenleitwerk
11-
Horizontal Stabilizer / Hohenleitwerk
12-
Elevator / Hohenruder