User Manual

2 mm
Clevis
Connector
...2
...2
Retract servo
Connector
Retract push-rod
Retract landing gear
X
Trial fit the push rod into the wing. Join the pushrod to
the retract gear arm and trial fit the retract into the wing.
Do the same way with other half wing.
Put the nylon ring
Retract push rod
Retract gear arm
Pull and push the retract push rod by hand to
be sure to adjust the stroke so that the landing
gear locks in both up and down position.
After checking that the retract works smoothly
fix the retract on the wing with 3x15mm screws
(included with VQ retract set)
X
Retract servo
Retract landing gear (left)
Retract landing gear (right)
FRONT
REAR
Do the same way with other half wing.
FRONT
3x15mm screw
( included with VQ retract set)
5-
Retract landing gear / Einziehfahrwerk
6-
Retract landing gear / Einziehfahrwerk
Bottom view /Ansicht von unten
WING - BOTTOM VIEW
UNTERSICHT
FRONT-VIEW
Vorderansicht
WING - BOTTOM VIEW
UNTERSICHT