User Manual

2.5x10mm
Adhesive
tape
1-Attach the board or transparent plastic on the side of
the fuselage with the adhesive tape as show.
2-Using a pencil or felt tipped pen trace around the engine
head where it meet the cowl. Cut the opening the board
or transparent plastic for the engine head as marked before.
3-Remove the engine and insert the cowl on to the fuselage
so the distance from the fire wall to the front of the cowl is
123 ~ 126mm. Trace around inside the hole on the board
or transparent plastic with a pencil.
4-Remove the cowl from the fuselage and carefully cut the
opening for the engine head as marked above. Do the same
way with the hole for needle-valve.
5-Again. Insert the cowl on to the fuselage and secure it in
place with five 2.5x10mm self tapping screws.
125mm
Ruler
Cut the opening
1.5mm
1/16”
2.5x10mm self
tapping screw
3/32x25/64” self tapping screw
.................5
Board or
transparent
plastic
Cut the opening
1.5mm
1/16”
Cowling / Motorhaube
23-