User Manual

X
25- Radio and battery
Elevator push rod
Throttle push rod
Rudder push rod
Tail wheel push rod
4-49/64”
(120mm)
2-61/64”
(75mm)
Carefully cut a 2-9/32”(58mm) wide area which is 2-61/64”
(75mm) in length through both the covering and the balsa
wood. Remove the excess balsa.
Put the battery pack into the box (pre-build at factory) and
fasten down with rubber bands or similar, ensuring it will not
come loose or rattle during flights.
Link the battery wire with the battery extension cord.
Reposition the hatch in place and secure it with CA glue.
Battery area
(in case of 4T engine)
BOTTOM VIEW
Battery area
(in case of 2T engine)
800-1000mah, flat pack
BOTTOM VIEW
Hatch
Hatch
2-9/32”
(58mm)
2”(51mm)
2-61/64”(75mm)
FUSELAGE
BOTTOM
X
To muffler
Filler tube
To engine
3x25mm
screw
Rubber stopper
1
After confirming the direction . Insert this assembly, clunk end first, into the fuel
tank and tighten and screw the fuel tank cap on firmly.
3x35 mm screw
4mm
2
23- Fuel tank
24- Electric motor
Firewall
125~127mm
(5-1/8”)
B’
B
B=B’
A
A=A’
A’
TOP-VIEW
SIDE-VIEW
! Engine thrust on balk head
is already adjust at factory
Using a aluminum motor mounting
plate as a template, mark the
plywood motor mounting plate
where the four holes are to be
drilled (2).
Remove the aluminum
motor mounting plate and
drill a 1/8”(3mm) hole
through the plywood at
each of the four marks
marked .
CA
1
3mm
2
Note: The aluminum motor mounting
included with electric motor set.
Checking for leaks - block the vents and blow into the feed - if in doubt submersing the tank in a blow of water will
show up any problems
3
4