User Manual

Plastic control horn
2x25mm screw
............................1
.......................2
Plastic back plate
...........................1
10mm
When you are satisfied with the
alignment of the control horn, mark
the mounting hole positions with a
felt tipped pen or a pencil.
Remove the control horn and drill
two 2mm (5/64”) holes through the
rudder
Insert the rudder push rod into the
rudder control horn. Attach the rudder
control horn using two 2x25mm screw
and a back plate.
20- Linkages / Anlenkungen
2x25mm screw
Rudder servo
2 mm
X
CA
X
CA
2 mm
Connector
Elevator push rod
Linkage stoper
Throttle push rod
Included with the
radio set
TOP VIEW
Draufsicht
Magnetic cockpit deck
21- Cockpit
TOP VIEW
Draufsicht
Throttle pushrod
Elevator pushrod
Tank
19- Linkages / Anlenkungen
Rudergestange