User Manual

4- Wheel pants installation / Fahrwerkseinbau
CA
“L”
For left wing
“R”
For right wing
1
2
Left ABS gear cover of “L” set
FRONT
REAR
Right ABS gear cover of “L” set
TOP VIEW
2- Cut away two holes on the top and
bottom of the right and left ABS gear cover
for the landing gear exit
3- Fit all ABS gear cover in place (L with L and R with R) and secure them
with CA glue
L/R
BOTTOM VIEW
1- Position the landing gear and strap as
show. Using the four 3x10mm screws, fasten
the landing gear to the bottom of the wing.
CAUTION: Push down the wheel pant
to this line.
3
4
Wheel pant
3x12mm
screw(2)
ABS gear cover
Nylon gear strap
Wheel
Stopper
CA
WING
Landing gear
5
6
7
8
5- Wheel pants installation / Fahrwerkseinbau
Stopper
Wheel
Nylon gear strap
3x12mm screw
Fiber glass wheel pant
FRONT VIEW
BOTTOM VIEW
Wooden block
Wooden block
Nylon gear strap
ABS gear cover
Fiber glass wheel pant
3mm screw
(black)
BOTTOM VIEW
4.3mm
4mm screws
4mm washer
4mm nut
...................4
...................4
..........4
1- Set the engine on the engine mounts
2- Place the engine mounts with the engine to the
fire wall and secure it with tittle CA glue.
3- Using a pencil or felt tipped pen, mark the engine
mounting plate where the four holes are to be drilled
4- Remove the engine and drill a 11/64” (4.3mm)
hole through the fire wall at each of the four marks
made in Step 3 above.
CAUTION: Align the mark on both mounts with the
center mark on the fire wall
CAUTION: Engine thrust on fire wall is aleady adjust
at factory
CAUTION: Align the engine center
with fire wall marked line
6- Engine mounts / Motortrager
Unteransicht
Vorderansicht
Unteransicht
Wooden dowel
Wooden dowel
CA
L/R