User Manual

L/R
BOTTOM VIEW
2x10mm
screw
X
X
Flap servo hatch
(plywood)
2- Servo installation / Servoeinbau
TOP
Flap servo hatch
Flap push rod
Push rod exit
Flap servo hatch
Flap servo
Servo mount
1- Place the flap servo onto the servo mounts and secure it in place using
the four screws included with the servo.
2- Install the flap push rod connector onto the hole in the flap servo arm
and insert the push rod through the push rod connector.
3- Place the flap servo hatch in its mount and secure it in place using four
2x10mm screws.
Flap push rod exit
L/R
Aileron servo
Aileron
push rod
CAUTION: one of the flap servos is revert servo
2x10mm screw
3- Servo installation / Servoeinbau
1.2mm
L/R
Plastic control horn
2x20mm screw
Linkage Stopper set
............................4
.......................8
......................2
BOTTOM VIEW
1-When you are satisfied with the alignment of the control horn mark the mounting hole
positions with a felt tipped pen or a pencil.
2-Remove the control horn and drill two 2mm (5/64”) holes through the ailerons and flaps.
3-Attach the control horn using two 2x20mm screw and a back plate.
Plastic control horn
Plastic back plate
2x20mm screw
2mm
2x20mm screw
2x20mm screw
1- Servo installation / Servoeinbau
Aileron servo
extension cord
X
BOTTOM
2mm
Unteransicht
Unteransicht