User Manual

CA
3x12mm screw
1.5mm
1/16
Tail gear horn
(3x12mm) screw
Tail gear horn
5/64”(2mm) collar
...........2
...............1
...............1
1-Place the tail gear mount on the bottom
of the fuselage as show, mark the
mounting hole positions with a pencil.
2-Remove the tail gear mount from the
fuselage, Drill the two mounting holes
as marked.
3-Cut a 5/64”(2mm) wide slot which is 5/16”
(8mm) length and 5/16”(8mm) depth on
the bottom of the rudder as shown.
4-Trial fit the tail gear horn into the slot. Do not glue at this time.
5-Slide the tail gear into the tail gear horn. Secure the tail gear
mount in place using the two 3x12mm screw.
6-Secure the tail gear horn in place using CA glue as shown.
1/8x15/32”
5/64”(2mm) collar
Tail gear mount
Tail gear / Heckspornrad
11-
FUSELAGE - BOTTOM VIEW
UNTERSICHT
1
2
3
Ply engine mount plate
SIDE VIEW
FRONT VIEW
4
5mm
135mm
Engine thrust on balk head is already adjust at factory
..........4
....................4
4x25mm screw
Blind-nut
(5-5/16”)
Engine 4T / Viertarkmotoren
12-
FRONT VIEW
5mm
Engine 2T / Zweitarkmotoren
13-