User Manual

1
2
3
STEP
STEP
STEP
Pillow ball
E-ring
RETRACT LANDING GEAR INSTALLATION
1/8x15/32”
(3x12mm)
screw
VQ-AR07 - 160227
Retract servo
(Purchase separately)
X
X
4-
Retract landing gear / Einziehfahrwerk
WING - BOTTOM VIEW
UNTERSICHT
WING - BOTTOM VIEW
UNTERSICHT
Ply gear mount plate x 2
Square plastic x 2
Main gear (left)
Main gear (right)
Gear mount x 2
Plastic strapX4
3x12mm screw.
Plastic strap
Main landing gear
Gear mount
(hard wood)
Ply gear
mount plate
Square plastic
......16
3x12mm screw
3x12mm screw
5-
Fixed gear / Starres Fahrwerk
Cut away only the film inside the line.
CA
1-Using the ABS retract shield as a template, trace around the
outside edge of the ABS retract shield, and then remove it.
2-Using a sharp hobby knife, cut away the covering inside the
lines. Not to cut into the wood.
3-Apply the ABS retract shield in place and secure with CA
glue.
R
“R” for the right half wing
“L” for the left half wing
6-
ABS Shield
WING - BOTTOM VIEW
UNTERSICHT