User Manual
A
B
A
B
C
B
C
A
CENTER
WING
SECTION
CA
CA
CA
CA
BOTTOM
Retract servo tray
Retract servo mount
Retract servo mount “B”is longer than “C”
Note:
BOTTOM
Retract servo
Retract servo
X
Install the retract servo onto the retract
servo mount and secure it in place with
four screw (included with radio set).
Note: The head of servo should be positioned
toward the front of the wing.
RETRACT SERVO INSTALLATION
A
B
Binder clip
Nylon wing bolt
Rubber band
(both the top
and bottom)
1-
Joining the wing / Flachenverbindung
2-
Retract Servo mount / Servoaufnahmen
TOP VIEW / AUFSICHT
TOP VIEW / AUFSICHT
TOP VIEW / AUFSICHT
3- Retract servo / Einziehfahrwerk servo
CENTER
WING
SECTION
1- Using a pencil, mark the center of the brace.
2- Trial fit the wing joiner into one of the wing panels. It should insert
smoothly up to the center line marked above.
3- Slide the other wing half onto the dihedral brace until the wing panel meet.
If the fit is over tight, it may be necessary to lightly sand the dihedral brace.
4- Check for the correct dihedral angle.
5- Mix approximately 30 minute epoxy and apply a generous amount of
epoxy into the wing joiner cavity of one wing half.
6- Coat one half of the dihedral brace with epoxy up to the center line. Install
the epoxy-coated side of the dihedral brace into the wing joiner cavity up to
the center line, marking sure that the “V” of the dihedral brace is positioned correctly
7- Do the same way with the other wing half.
8- Carefully slide the wing halves together, ensuring that they are accurately aligned.
Firmly press the two halves together, allowing the excess epoxy to run out. Clear off
the excess epoxy.
IMPORTANT:
Please do not clean off the excess epoxy on the wing with strong solvent or
pure alcohol, only use kerosene to keep the colour of your model not fade.