User Manual

Canopy / Kabinenhaube
20-
2x10mm screw
............4
1.5mm
U
D
T
S
CHECKER TAIL VERSION
CHINESE AIR-FORCE
US.ARMY
Note: Cut out the stickers and apply them in the proper area. Do not peel the backing paper off all at once.
Peel off one corner of the backing and cut off with scissors. Arrange sticker on model and when satisfied adhere the
corner without backing.
Carefully peel back the rest of the backing while at the same time adhering the rest of the sticker.
Try not to make air bubbles, if there are some, carefully puncture sticker (center of bubble) but not model surface
with the tip of the knife or sharp pin and squeeze out the air. At curves stretch sticker and apply a little heat so that no
ceases occur. Cut off the excess that is produced.
VQA022C AVG
VQA020B
Decor / Aufkleber
21-