User Manual

Table Of Contents

6mm

Carefully remove the engine mount beams

and drill a 6mm hole through the fire-wall

at each of the four marks made above (9C)

Reposition the engine mount beams on to

the fire-wall and secure them with four

4x25mm screw (9D)

Insert the blind-nut with the wooden washer onto each

of the four holes make above.

Position the engine to the engine mounts so the distance

from the prop hub to the fire-wall is 110-115mm.

Mark the engine mounting plate where the four holes

are to be drilled (9E)

Remove the engine and drill a 3mm holes through the

beam at each of the four marks made above (9F)

Reposition the engine on the engine mount beams, aligning

it with the holes. Secure the engine to the engine mount

using four 3x25mm screws (9G)

To muffler

Filler tube

To engine

3x35mm screw

Rubber stopper

Checking for leaks - block the vents and blow into the

feed - if in doubt submersing the tank in a blow of

water will show up any problems (10B).

Blow

Water

Carefully install the fuel tank

to ensure that they will not

shift during flight (10C).

10A

3mm

10-FUEL TANK

10B

10C