User Manual

A
B
A
B
A
B
A
B
A
B
Using a pencil, mark the center of the brace.
This mark will serve as the center line when
joining the wing halves.
Coat one half of the dihedral brace with epoxy up to the center line.
Install the epoxy-coated side of the dihedral brace into the wing
joiner cavity up to the center line, making sure that the “V” of the
dihedral brace is positioned correctly.
Apply the generous amount of epoxy into the wing cavity of the center
wing.
Smear epoxy on all sides of the exposed area of the dihedral brace
and uniformly coat both wing roots with epoxy.
Carefully slide the wing halves together, ensuring that they are
accurately aligned.
Firmly press the two wing halves together, allowing the excess epoxy
to run out. Using kerosene and paper towel, clean off the excess
epoxy
WARNING: Securely glue together, if coming of
during flights, you lose control of your plane
which lead to accidents.
IMPORTANT: Please do not clean off the excess epoxy on the wing
with strong solvent or pure alcohol, only use kerosene to keep the
colour of your model not fade.
L/R
Assemble left and right
wings the same way.
3-WING
3A
3B
3C