User Manual

Plastic control horn
2x12mm screw
............................3
.......................6
Plastic back plate
...........................3
Remove the rudder and drill a 2mm diameter
hole in torque rod mounting slot, making sure that you
drill the hole perpendicular to the leading edge of the
rudder.
2mm
Cut the long slot along the hinge line in the
trailing edge of the rudder for the tail gear
Push the rudder pushrod into the black nylon pushrod
guide as shown (14E).
Black nylon pushrod guide
Using the back plate of control horn as a template, mark
the mounting hole positions, where the rudder clevis
meets the rudder with a felt tipped or a pencil (14E).
Remove the back plate control horn and drill two 2mm
holes through the rudder (14F).
Attach the rudder control horn using the hardware provided
(two 2x15mm screws and a back plate).(14F)
Control horn Alignment
STABILIZER
2mm
2mm
14c
14D
(See 13B)
14E
14F
Do the same way with the elevator control horn.