User Manual

Table Of Contents

Apply thin CA

glue on the top

of the hinge

Without using glue yet, push the elevator and its

hinges into the hinge slots in trailing edge of the

horizontal stabilizer (13A).

Apply a thin layer of petroleum jelly

HORIZONTAL STABILIZER

Apply thin CA

glue on the top

of the hinge

TOP-SIDE

Do the same way with the bottom side of elevator and

with the second elevator and rudder.

Without using glue yet, push the rudder and its hinges into the

hinge slots in the trailing edge of the vertical stabilizer.

When satisfied with the alignment, mark the mounting hole

position, where the tail gear meets the rudder with a pencil.

13-ELEVATOR

13A

13B

14-RUDDER

14A

14B

3X12mm screw

............4

2.2mm collar

............1

25mm wheel

........1