User Manual

Trial fit the vertical fin in position. Using
a 90 degree triangle, ensure that the
vertical stabilizer is perpendicular to the
horizontal stabilizer (12B).
Using a pencil, trace around the vertical
stabilizer where it meets the fuselage.
Remove the vertical stabilizer from the
fuselage. Using s sharp hobby knife,
carefully cut away the covering below the
lines which were drawn in the previous
steep. Do not cut into the woods as this
will affect the structural integrity of the
stabilizer (12C).
Cut away only
the covering
both side
Insert the vertical fin into the fuselage,
precisely align the vertical stabilizer
as described in step 12B.
Apply the thin CA glue on the vertical
stabilizer where it contacts the fuselage
(12D).
CA
Apply thin CA
glue both side
! Securely glue together. If coming off during fly, you lose control of your air plane.
B
B’
B=B’
90 degree
triangle
Pull the rudder out of the vertical fin.
Carefully, push the vertical fin into the
slot on the fuselage as shown (12A).
12-VERTICAL STABILIZER
12A
12B
12C
12D