Installation Instructions

RUBBER FLOORING
Installation and Maintenance
Instructions
VPI Corporation
3123 S. 9
th
Street
P.O. Box 451
Sheboygan, WI 53082-0451, U.S.A.
920-458-4664 ● Fax [phone]
www.vpicorp.com
Install & Maint. Treads, Risers & Nosings 15: 03-11-15
RUBBER STAIR NOSING INSTALLATION
1. Make sure all conditions are met regarding surface preparation before starting the installation.
2. Fill any voids in the wood or concrete steps with a cementitious-based patching compound.
3. Measure, scribe, trim and dry-fit the stair nosing to each step.
4. Wipe the back of the trimmed nosing with a clean dry cloth to remove any debris.
5. Mix the Adhesive for the steps according to the directions, using correct trowel.
6. Press the nosing uniformly and firmly to the step edge.
7. Press the step portion of the nosing down from front to back.
8. Roll nosing with hand roller.
MAINTENANCE PROCEDURES
Allow the adhesive on the installed treads to thoroughly dry before completing the initial maintenance.
Initial maintenance and normal maintenance procedures are as follows:
1. Treads are maintained by hand.
2. Wet mop or dust mop to remove dust and debris.
3. Clean the factory residue from the tread using PRT Initial Deep Scrub and a water solution. Allow
5 – 10 minutes and then scrub with a red pad or bristle brush.
4. Mop off the excess solution per instructions.
5. Rinse the treads with clear water to neutralize, and allow the treads dry.
6. Apply PRT Flex Shield for a high gloss or PRT Satin Flex Shield to seal the pores on the surface.
7. Clean treads as using VPI PRT Ongoing Cleaner as conditions and soiling dictate.
Any questions about surface preparation, sub floor conditions or general
installation questions or maintenance not covered in these instructions, please
contact VPI.