User manual

8
The plugin is now available in the selected slot within the board.
Above the name of the program is a detail that informs the user
about the request for resources by the plugin.
If the
were to become red, it is possible that the request of resources is
greater than that available with the possibility of running into
problems in the audio.
Note that you can load the same plugin 2 or more times, adjacent
or not, in the same board. In this case, the plugin will assume the
characteristic of exclusivity, and mode “One pedal at a time”, will
automatically be assigned only for the plugin loaded in two or
more slots in the same board. This mode is useful if you want to
use the same plugin with 2 or more programs (presets) with different settings. Note that if a plugin loaded multiple times is replaced or
unloaded, also the other instances of the plugin will be discharged by the board.
To empty a slot or replace a plugin and edit a plugin parameters
Press and hold the "PAGE / ENTER" at a slot where a plugin is loaded, and then release when you enter the editing mode of the
selected plugin. This page can be scrolled using the footswitches corresponding arrows , to view
and load programs (presets) that may be available or created by the user. Note or the plugins factory programs, if there are any, they
will be displayed and available, but programs are not always available for all plugins, so in this case it will be necessary to take action
directly in the graphical view of the plugin, and through the use of the mouse, select the program (preset), if available. Subsequently,
the program is loaded, you can save and assign a name to the loaded program, to get immediate access to the program (preset).
This mode of programs (preset) selection, can be very useful during live performances, especially if you are using plugins that include
a complete set of effects (e.g. amp + cab + Sfx). Creating more presets to
your liking, you will be able to quickly load them scrolling the list. For this
type of use, the parameter "Load the program while scrolling the list" in
this global setup must be enabled (YES). Note that in this screen,
"VALUE" knob acts on the output level of the plugin that you are editing,
helping to adjust the output level of each plug-in, operation that in some
cases can be a bit boring.
Press Holding down the PAGE/VALUE button for at least one
second, you will enter the list of the installed plugins. You can replace a plugin
by choosing it from the list, or empty the slot that you are working on, by
pressing the button corresponding to
Still in this screen, pressing and holding the "PAGE / ENTER" button for one second, takes you to the screen where you can change
the parameters of the plugin you are working on. The methods of intervention are 2:
1) Editings can be made by the use of the supplied mouse, working on the almost always available plugin GUI, but you can apply
editings without using the mouse, selecting a parameter by using the buttons corresponding to the arrows .
The parameter name will be shown on right of the display,
After selecting the desired parameter, change the value using
the "VALUE" knob. The numeric value will be displayed,
during the intervention on "VALUE", in the space where before
was shown the parameter name.
Note that the editing of a parameter of a plugin can also be done
through the exclusive use of footswitches, so if necessary, it can be done quickly even during a live performance.
BACK
NO EFF
as in the picture here on the right
VIRTUAL LED
BACK