User manual

7
NOTE: In the "EFFECT INSTALLER" and confirm installation screens, is
still available the "BROWSE" option, which allows to navigate in a section
containing system files more in-depth than the one displayed by entering
"BROWSE" from the installation screen. Improper modifications may
degrade or in any way impede the proper functioning of vPed. Should it be
necessary access to this section it's highly recommended to apply
changes with caution and knowledge of the facts by applying changes to
this section. In this case too can't be held in any way
responsible for any malfunction or other due to changes applied in this
section. Press "ACCEPT" to enter the vPed structure, or "DECLINE "
button to return to the previous screen. In this mode, the use of a mouse is
essential.
It’s 'possible that some dll installations, require to copy an entire folder (containing for example. Dat file / samples impulses / presets /
etc.). In this case, simply drag the entire folder. Exiting the installation page, vPed will install the plugin equally.
Installation with "SETUP"”
While installing plugins with setup, or in any software that install using an executable program, you will need to use the mouse. Run
the "setup" and follow the on-screen instructions provided by the program, which may vary according to the installation program that
you are using. If it should be necessary to connect a network, use the Ethernet port available on the left side of vPed. At the end of the
installation procedure, follow steps similar to the installation of dll.
Notes about plugin installation with SETUP file:
Both in case of installation using setup or dll, it is highly recommended to install a plugin at a time, confirming the installation
If during the installation it's proposed to change the address of installation, check and if necessary correct the installation path
so that it is in any of the locations included in "C: \”
During the installation using "setup", if the program requires it, you should only enable the installation of VST / VSTi, disabling
all other installation options.
It 'possible that, after after the launch of a SETUP program, it may take a few seconds before the installation begins.
Uninstalling a plugin
Enter in UTILITY and select "Uninstall EFFECT". Afterwards you
will see a list of installed plugins. Select the plugin you want to
uninstall and press "PAGE / ENTER". In the lower part of the
screen there is the "OTHER" option, which can be used in the
possible but rare case that a plugin does not appear in the
uninstall list. In this box, which proposes a standard uninstaller,
it's necessary to use the mouse. Caution is advised in the use of
the functions available in the "Add / Remove Programs", visible
after pressing the button corresponding to "OTHER".
can't be held in any way responsible for any
malfunction or other problems due to inappropriate changes applied in this section.
Loading a plugin
In the image below, the board has not uploaded any effect, and only the space available for the first group of 4 slots to which you can
assign plugins is displayed, in positions 1 to 4, corresponding to the underlying footswitches.
The first group of slots 1-4 is also shown in the upper part of the screen
To view the second group of 4 slots , press the
footswitch corresponding to "PAGE / ENTER" once.
Once you have installed a plugin, to make it available to the
board from the Home screen press and hold the button
corresponding to the slot in which you want to load the plugin for
at least one second, accessing the list of available plugins. Select
the effect you want with the help of the “VALUE” dial.
Highlight the item you want to load and press "PAGE / ENTER"
button to load the selected plugin.